 |
|||
|
|
|||
|
Page Title:
STEERING GEAR REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0458 00
STEERING GEAR REPAIR (Contd)
ASSEMBLY
CAUTION
Assembly area must be free of dirt and grease. Dirt or grease
may damage internal steering gear components.
1.
Install new seal (9) in gear housing (3).
2.
Clamp gear housing mounting flange (11) in vise with cam (5) bore positioned up.
3.
Install cup (7) over end cover tube (8) and seat in gear housing (3).
4.
Lubricate cam bearings (29) and (6) with oil prior to cam (5) installation.
5.
Install cam bearings (29) and (6) and cup (28) on cam (5).
6.
Install cam (5) over end cover tube (8) through gear housing (3) and seat bearing (6) on cup (7).
NOTE
Apply sealing compound to all plugs prior to installation.
7.
Install plugs (10), (12), and (16) in gear housing (3) and side cover (21).
8.
Position new gasket (26), shim(s) (27), new gasket (26), gear tube cover (25), and gear tube (22)
over cam (5) on gear housing (3) and install with four washers (23) and new screws (24). Tighten
screws (24) 35 lb-ft (47.5 Nm).
9.
Using 3/8-in. drive torque wrench, ensure rotational drag on cam end (30) is 38 lb-in. (0.30.9 Nm).
NOTE
If rotational drag on shaft is not within specifications, add or
remove smallest shim for each adjustment until specifications
are met.
10.
Lubricate pitman shaft bearings (14) with gear oil prior to pitman shaft (13) installation.
11.
Install pitman shaft (13) in gear housing (3).
12.
Install new gasket (15) and side cover (21) on gear housing (3) with six washers (20) and screws (19).
13.
Install preload screw (17) with nut (18) in side cover (21). Do not tighten screw (17) or nut (18).
14.
Install steering gear (WP 0192 00).
11
3
9
10
12
8
16
15
14
7
13
6
5
5
30
26
17
29
27
28
26
25
21
23
20
19
18
24
22
22
END OF WORK PACKAGE
0458 00-7/8 blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version