 |
|||
|
|
|||
|
Page Title:
PARKING AND SERVICE BRAKEDRUM REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0456 00
PARKING AND SERVICE BRAKEDRUM REPAIR (Contd)
CLEANING AND INSPECTION
WARNING
Do not use compressed air or dry brush for cleaning when
working in areas of vehicle where asbestos brake lining dust
may accumulate. Remove asbestos dust and other residue
from these areas using a soft bristle brush or cloth soaked
with water. Breathing asbestos dust may cause injury to
personnel.
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap
and water. Wash contaminated clothing before reuse. Eye
contact may cause irritation, tearing, or blurring of vision. Use
face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at
least 15 minutes or until irritation subsides. Inhalation may
cause irritation to upper respiratory passages. DO NOT have
food or drink in the vicinity. Failure to comply may result in
injury to personnel.
1.
Clean parking or service brakedrums (1) or (2) with Skysol 100 and soft bristle brush. Allow to
air dry.
2.
Inspect parking or service brakedrums (1) or (2) for warps or cracks. Replace if warped or cracked.
3.
Inspect parking or service brakedrums (1) or (2) for scores or pits. If scored or pitted, measure
inside diameter.
a. Replace parking brakedrum (1) if inside diameter is greater than 13.41 in. (34.06 cm).
b. Replace service brakedrum (2) if inside diameter is greater than 15.0 in. (38.1 cm).
4.
If inside diameter is less than 13.41 in. (34.06 cm) for parking brakedrum (1) or less than
15.0 in. (38.1 cm) for service brakedrum (2), repair (1) or (2), as necessary.
REPAIR
1.
Remove scores or pits from parking brakedrum (1) or service brakedrum (2) by machining
(TM 9-4910-482-10).
2.
If parking brakedrum (1) or service brakedrum (2) were machined, measure inside diameter. If
inside diameter measurement is greater than limits, replace parking brakedrum (1) or service
brakedrum (2).
3.
Install service or parking brake (WP 0187 00 or WP 0188 00).
0456 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version