DIFFERENTIAL CARRIER REPAIR - continued

TM 9-2320-361-24-2

0455 00

DIFFERENTIAL CARRIER REPAIR (Contd)

ASSEMBLY AND ADJUSTMENT (Contd)

65.

Install new safety wire (11) on two screws (10).

66.

Install bearing cover (8) and shims (9) on carrier (12) with six new lockwashers (6) and screws (7).

Tighten screws (7) 6585 lb-ft (88115 Nm).

67.

Remove flange (4) from pinion end of shaft (13).

68.

Perform step 69 if dirt deflectors (5) were removed.

69.

Install two dirt deflectors (5) on two flanges (4).

NOTE

Apply light coat of GAA grease to splines of flanges before

installation.

Flanges must be installed with four holes aligned.

Before tightening nuts, secure flanges in vise.

Ensure cotter pin holes are aligned before removing carrier

from vise.

70.

Install spacer (14) and two flanges (4) on carrier (12) with two washers (3) and nuts (1). Tighten

nuts (1) 300600 lb-ft (407814 Nm).

71.

Install two new cotter pins (2) in two nuts (1).

0455 00-24