 |
|||
|
|
|||
|
Page Title:
DIFFERENTIAL CARRIER REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0455 00
DIFFERENTIAL CARRIER REPAIR (Contd)
DISASSEMBLY
CAUTION
Scribe or center punch alignment marks on each side of carrier
for easy identification. Improper installation will result in
damage to parts.
1.
Scribe or center punch alignment marks on bearing caps (1) and carrier (17).
2.
Remove two safety wires (5), two screws (3), and adjusting nut locks (2) from bearing caps (1).
Discard safety wires (5).
3.
Remove four screws (4), washers (6), and two bearing caps (1) from carrier (17).
CAUTION
Scribe or center punch alignment marks on case halves and
helical drive gear. Marks should match those placed on bearing
caps. Improper installation will result in damage to equipment.
4.
Scribe or center punch alignment marks on case halves (12) and (22) and helical drive gear (19).
5.
Remove bearing seats (16) and adjusting nuts (15) from differential gear assembly (18).
6.
Secure differential gear assembly (18) in vise.
7.
Remove safety wire (20), eight nuts (21), and screws (14) from case halves (12) and (22). Discard
safety wire (20).
8.
Remove case half (12) from helical drive gear (19).
9.
Remove spider (7) with four thrust washers (9), pinion gears (8), two side gears (10), and thrust
washers (11) from case half (22).
NOTE
If washers, gears, and spider are not to be replaced, retain them
together and proceed to step 11.
10.
Remove four thrust washers (9) and pinion gears (8) from spider (7).
11.
Remove two side gears (10) and thrust washers (11) from spider (7).
12.
Remove helical drive gear (19) from case half (22).
NOTE
Prior to removal, tag bearings for installation.
13.
Using mechanical puller, remove two bearings (13) from case halves (12) and (22).
0455 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version