Click here to make tpub.com your Home Page

Page Title: DIFFERENTIAL CARRIER REPLACEMENT - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-361-24-2
0454 00
DIFFERENTIAL CARRIER REPLACEMENT (Contd)
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use, and disposal of these liquids. Failure to
do so may result in damage to environment and health of
personnel.
CAUTION
Work area should be clean, well-ventilated, and free from
blowing dust and dirt. Damage to equipment could result if area
is not clean.
NOTE
Use a drain pan to capture any draining oil. Dispose of fluids in
accordance with local policy and ordinances. Ensure all spills
are cleaned up.
REMOVAL
1.
Remove drain plug (12) from bottom of housing (6) and drain gear oil.
2.
Remove eight nuts (1) and washers (2) from eight studs (3).
3.
Loosen four remaining nuts (10) on studs (8).
4.
Remove screw (5) and washer (4) from carrier (7).
5.
Install utility chains on carrier (7) with washer (4) and screw (5). Attach lifting device on utility
chains.
WARNING
All personnel must stand clear during lifting operations.
A swinging or shifting load may cause injury or death to
personnel.
CAUTION
When lifting differential carrier out of axle housing, use care
not to damage mounting studs.
NOTE
Assistant will help with steps 6 and 7.
6.
Using lifting device, raise carrier (7) 1/2 in. (1.3 cm) out of housing (6) and remove four remaining
nuts (10) and washers (9) from studs (8).
7.
Remove carrier (7) from housing (6).
8.
Remove gasket (11) from housing (6). Discard gasket (11).
9.
Lower carrier (7) to workbench and remove lifting device from utility chains.
10.
Remove screw (5), washer (4), and chains from carrier (7).
INSTALLATION
1.
Install chains on carrier (7) with washer (4) and screw (5).
2.
Install new gasket (11) on housing (6).
3.
Install lifting device on utility chain.
0454 00-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business