 |
|||
|
|
|||
|
Page Title:
ENGINE COOLANT HEATER COMPONENT BRACKET MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0420 00
ENGINE COOLANT HEATER COMPONENT BRACKET MAINTENANCE (Contd)
ASSEMBLY
1.
Install receptacle (16) on heater component bracket (14) with four new screw-assembled
lockwashers (20).
2.
Install resistor holder (18) on heater component bracket (14) with new nut-assembled
lockwasher (15).
3.
Install resistor (1) on resistor holder (18) with screw (19) and new nut-assembled lockwasher (17).
4.
Install terminal strip (12) and spacer (13) on heater component bracket (14) with four new
screw-assembled lockwashers (11).
5.
Install diode holder (5) on heater component bracket (14) with screw (7).
6.
Install diode (6) on diode holder (5) with arrow pointed in direction previously noted.
7.
Install resistor leads (2) and (9), diode lead (4), and diode holder (5) on terminal strip (12) with
screw-assembled lockwashers (3), (8), and (10).
INSTALLATION
1.
Install heater component bracket (14) on heater housing (34) with four screws (30).
2.
Install leads (26), (27), and (29) on heater component bracket (14) with two new screw-assembled
lockwashers (28).
3.
Place grommet (33) on leads (27) and (31) and install on heater housing (34).
4.
Install leads (21), (22), (24), and (37) on flame detector switch (35) with three new screw-assembled
lockwashers (23).
5.
Install leads (31) and (27) on restriction thermostat (32).
6.
Install new tiedown strap (25) around wires.
7.
Install engine coolant heater blower motor (WP 0418 00).
8.
Connect battery ground cable (WP 0126 00).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0420 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version