 |
|||
|
|
|||
|
Page Title:
CAB REINFORCEMENT REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0414 00
CAB REINFORCEMENT REPLACEMENT (Contd)
REMOVAL
1.
Remove twelve screws (1), locknuts (7), seat catch (2), if equipped, and cab reinforcement plate (3)
from rear cab wall (8). Discard locknuts (7).
2.
Remove seventy-seven blind rivets (5) and cab reinforcement panel (6) from rear cab wall (8).
Discard blind rivets (5).
NOTE
Right and left rear pillar gussets are removed the same way.
This procedure covers the left rear pillar gusset.
3.
Remove eight blind rivets (5) and rear pillar gusset (4) from rear cab wall (8). Discard blind
rivets (5).
4.
Remove screw (12), lockwasher (11), and front pillar nut assembly (10) from front door pillar (9).
Discard lockwasher (11).
INSTALLATION
1.
Install front pillar nut assembly (10) with new lockwasher (11) and screw (12).
2.
Install rear pillar gusset (4) to rear cab wall (8) with eight new blind rivets (5).
3.
Install cab reinforcement panel (6) to rear cab wall (8) with seventy-seven new blind rivets (6).
4.
Install cap reinforcement plate (4) and seat catch (3), if equipped, to rear cab wall (8) with thirteen
screws (1) and new locknuts (7).
5.
6.
7.
Install cab top (TM 9-2320-361-10).
8.
Install cab doors (WP 0209 00).
9.
Connect battery ground cable (WP 0126 00).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0414 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version