|
|
TM 9-2320-361-24-2
0402 00
SWINGFIRE HEATER WATER HOSES REPLACEMENT (Contd)
REMOVAL
1.
Remove clamps (3) and (7), outlet hose (2), and inlet hose (1) from outlet port (4) and inlet port (6)
on water jacket (5).
2.
Remove clamps (19) and outlet hose (1) from adapter (18).
3.
Remove two locknuts (21), screws (23), clamps (20), and outlet hose (1) from fender (22).
Discard locknuts (21).
4.
Remove clamp (8) and inlet hose (2) from adapter (9).
5.
Remove adapter (9) from elbow (10).
6.
Loosen jamnut (11) and remove elbow (10) and O-ring (12) from engine (13). Discard O-ring (12).
7.
Remove adapter (18) from fitting (17).
8.
Loosen jamnut (16) and remove fitting (17) and O-ring (15) from water pump housing (14).
Discard O-ring (15).
INSTALLATION
1.
Apply sealant to male threads of adapters (9) and (18).
2.
Install new O-ring (15) and fitting (17) on water pump housing (14) and tighten jamnut (16).
3.
Install adapter (18) on fitting (17).
4.
Install new O-ring (12) and elbow (10) on engine (13) and tighten jamnuts (11).
5.
Install adapter (9) on elbow (10).
6.
Install inlet hose (2) on adapter (9) with clamp (8).
7.
Install outlet hose (1) on adapter (18) with clamp (19).
8.
Install outlet hose (1) and two clamps (20) on fender (22) with two screws (23) and new
locknuts (21).
9.
Install outlet hose (1) on inlet port (6) on water jacket (5) with clamp (7).
10.
Install inlet hose (2) on outlet port (4) on water jacket (5) with clamp (3).
11.
Fill swingfire heater water jacket to proper level (WP 0401 00).
12.
Fill cooling system to proper level (WP 0076 00).
13.
Lower hood and secure (TM 9-2320-361-10).
14.
Connect battery ground cable (WP 0126 00).
15.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0402 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |