 |
|||
|
|
|||
|
Page Title:
SLAVE RECEPTACLE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0365 00
SLAVE RECEPTACLE REPLACEMENT (Contd)
REMOVAL
1.
Remove locknut (19), two lockwashers (18), ground cable (5), and screw (17) from rear battery
support hanger (16). Discard locknut (19) and lockwashers (18).
2.
Remove nut (33), screw (31), and positive cables (22) and (34) from positive battery terminal (32).
3.
Remove screw (27) washer (26), lockwasher (25), two clamps (24), ground cable (5), and positive
cable (22) from cab back panel support (23). Discard lockwasher (25).
4.
Remove two grommets (24), positive cable (22), and ground cable (5) from cab floor (29).
5.
Remove four locknuts (20) and screws (21) from cab (9) and reinforcement plate (10). Discard
locknuts (20).
6.
Remove four locknuts (14), lockwashers (15), screws (1), lockwashers (2), slave receptacle cap (30),
seal (8), reinforcement plate (10), seal (11), plate (12) and slave receptacle (4) from cab (9). Discard
locknuts (14), lockwashers (15), and lockwashers (2).
7.
Remove cover (13), two screws (6), washers (7), positive cable (22), and ground cable (5) from slave
receptacle (4).
8.
Remove positive cables (22), and ground cable (5) from cab (9).
INSTALLATION
1.
Install positive cables (22), and ground cable (5) on cab (9).
2.
Install positive cable (22), and ground cable (5) on cab (9) with two screws (6), washers (7) and
cover (13).
3.
Install slave receptacle (4), slave receptacle cap (30), seal (8), reinforcement plate (10), seal (11),
plate (12), with four screws (1), new lockwashers (2), new lockwashers (15), and new locknuts (14)
on cab (9)
4.
Install four screws (21) and locknuts (20) on slave receptacle (4) and reinforcement plate (10).
5.
Install two grommets (24), positive cable (22), and ground cable (5) on cab floor (29).
6.
Install ground cable (5), and positive cable (22) on cab back panel support (23) with screw (27)
washer (26), lockwasher (25), and two clamps (24).
7.
Install positive cables (22) and (34) on positive battery terminal (32) with screw (31) and nut (33).
8.
Install ground cable (5) on rear battery support hanger (16) with screw (17), two lockwashers (18),
and locknut (19).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0365 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version