|
|
TM 9-2320-361-24-2
0364 00
ALCOHOL EVAPORATOR MAINTENANCE (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flames. Injury or death to personnel may result.
REMOVAL
1.
Remove jar (9) and O-ring (8) from evaporator body (7).
2.
Disconnect tube (5) from compressor elbow (13) and adapter (6).
3.
Remove three locknuts (11), screws (12), and evaporator body (7) from bracket (1). Discard
locknuts (11).
4.
Disconnect adapter (6) from evaporator body (7).
5.
Disconnect tube (3) from outlet manifold (2).
6.
Remove two screws (4), outlet manifold (2), and bracket (1) from compressor (10).
INSPECTION
Inspect O-ring (8) for rips, tears, or other damage. Replace O-ring (8) if ripped, torn, or damaged.
INSTALLATION
1.
Install bracket (1) and outlet manifold (2) on compressor (10) with two screws (4).
2.
Connect tube (3) to outlet manifold (2).
NOTE
Apply sealing compound to adapter prior to installation.
3.
Install adapter (6) on evaporator body (7).
4.
Install evaporator body (7) on bracket (1) with three screws (12) and new locknuts (11).
5.
Connect tube (5) to compressor elbow (13) and adapter (6).
6.
Install O-ring (8) and jar (9) on evaporator body (7).
7.
Fill evaporator jar, start engine (TM 9-2320-361-10), and check alcohol evaporator operation.
8.
Connect battery ground cable (WP 0126 00).
9.
Lower and secure hood (TM 9-2320-361-10).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0364 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |