 |
|||
|
|
|||
|
Page Title:
ENGINE COOLANT HEATER REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0357 00
ENGINE COOLANT HEATER REPLACEMENT (Contd)
REMOVAL
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use, and disposal of these liquids. Failure to
do so may result in damage to environment and health of
personnel.
NOTE
Prior to removal, close fuel shutoff, engine oil, and water
manifold valves.
Use a drain pan to capture any draining fluids. Dispose of
fluids in accordance with local policy and ordinances. Ensure
all spills are cleaned up.
1.
Disconnect harness (3) from heater (4).
2.
Disconnect fuel line (1) from elbow (14).
3.
Remove clamp (13) and hose (12) from elbow (11).
4.
Remove cotter pin (10) and elbow (8) from heater (4). Discard cotter pin (10).
5.
Remove clamp (6) and hose (5) from elbow (7).
6.
Remove two clamps (9) and heater (4) from saddle brackets (2).
INSTALLATION
1.
Install heater (4) on saddle brackets (2) with two clamps (9).
2.
Install hose (5) on elbow (7) with clamp (6).
3.
Install elbow (8) on heater (4) with new cotter pin (10).
4.
Install hose (12) on elbow (11) with clamp (13).
5.
Connect fuel line (1) to elbow (14).
6.
Connect harness (3) to heater (4).
7.
Connect battery ground cable (WP 0126 00).
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0357 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version