115- AND 24-VOLT WIRING HARNESS REPLACEMENT - continued

TM 9-2320-361-24-2

0315 00

115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd)

REMOVAL (Contd)

NOTE

Perform steps 41 and 42 for M185A3 vehicles.

41.

Remove bushing (5) from nipple (6) and safety switch box (2).

42.

Remove START/STOP switch (9), two screws (7), switch bracket (8), and spacer (10) from van

wall (11).

43.

Remove four nuts (4), lockwashers (3), and safety switch box (2) from two mounting brackets (1).

Discard lockwashers (3).

NOTE

Safety wire will be used to install new wiring harness. Do not

cut safety wire from spool until harness has been pulled from

van and proper length has been obtained.

44.

Attach safety wires (14) to wire leads (12), (13), (16), (18), and (19).

45.

Remove three grommets (17) from van wall (11) and wire leads (12), (13), and (16).

46.

Remove two grommets (20) from van wall (11) and wire leads (18) and (19).

47.

Pull wire leads (12), (13), (16), (18), and (19) out of van wall (11).

48.

Remove safety wires (14) from wire leads (12), (13), (16), (18), and (20).

49.

Cut safety wires (14) from spools (15).

0315 00-10