 |
|||
|
|
|||
|
Page Title:
WIRE PLUG WIRING HARNESS REPLACEMENT (M109A3) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0314 00
WIRE PLUG WIRING HARNESS REPLACEMENT (M109A3) (Contd)
CAUTION
Use care when removing or installing wiring harnesses.
Excessive snagging or pulling may damage wires.
REMOVAL
NOTE
Prior to removal, tag leads wires, cables, and terminals for
installation.
1.
Remove eight screws (1) from two housings (2) and van wall (3).
2.
Remove two snaprings (8) from two wire plugs (7).
3.
Remove two wire plugs (7) from two housings (2).
NOTE
Safety wire will be used to install new wiring harness. Do not
cut safety wire from spool until wiring harness has been pulled
through van wall and proper length has been obtained.
4.
Using electrical tape, attach safety wire (5) to one end of wiring harness (4).
5.
Pull on other end of wiring harness (4) and remove wiring harness (4) from van wall (3).
6.
Remove wiring harness (4) from safety wire (5).
7.
Cut safety wire (5) from spool (6).
INSTALLATION
1.
Attach safety wire (5) to one end of wiring harness (4).
2.
Pull safety wire (5) and wiring harness (4) through van wall (3).
3.
Remove safety wire (5) from wiring harness (4).
4.
Position two snaprings (8) on two wire plugs (7).
5.
Install two snaprings (8) and two wire plugs (7) in two housings (2).
6.
Install two housings (2) on van wall (3) with eight screws (1).
7.
Connect battery ground cable (WP 0126 00).
8.
Place safety switch in ON position (TM 9-2320-361-10).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0314 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version