 |
|||
|
|
|||
|
Page Title:
24-VOLT DC RECEPTACLE REPLACEMENT (M185A3) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0310 00
24-VOLT DC RECEPTACLE REPLACEMENT (M185A3) (Contd)
CAUTION
Use care when removing or installing wiring harnesses.
Excessive snagging or pulling may damage wires.
REMOVAL
NOTE
Prior to removal, tag lead wires and terminals for installation.
1.
Slide handle (4) on safety switch box (3) to OFF position and open cover (1).
2.
Loosen two screws (2) and remove two wires (5) from safety switch box (3).
3.
Remove two screws (10) and cover (9) from START/STOP switch (8).
4.
Remove three screws (7) and wires (6) from START/STOP switch (8).
5.
Using electrical tape, attach safety wire (11) to two wires (5) and three wires (6).
6.
Remove four screws (15), lockwashers (14), receptacle (13), two wires (5), three wires (6), and
gasket (12) from van body (16). Discard gasket (12) and lockwashers (14).
7.
Remove two wires (5) and three wires (6) from safety wire (11).
INSTALLATION
1.
Using electrical tape, attach safety wire (11) to two wires (5) and three wires (6).
NOTE
Assistant will help with step 2.
2.
Pull two wires (5) and three wires (6) through van body (16).
3.
Install new gasket (12) and receptacle (13) on van body (16) with four new lockwashers (14) and
screws (15).
4.
Remove safety wire (11) from two wires (5) and three wires (6).
5.
Install two wires (5) on safety switch box (3) by tightening two screws (2).
6.
Install three wires (6) on START/STOP switch (8) with three screws (7).
7.
Install cover (9) on START/STOP switch (8) with two screws (10).
8.
Close cover (1) on safety switch box (3) and slide handle (4) to ON position.
9.
Connect battery ground cable (WP 0126 00).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0310 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version