 |
|||
|
|
|||
|
Page Title:
115-VOLT AC RECEPTACLE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0309 00
115-VOLT AC RECEPTACLE REPLACEMENT (Contd)
CAUTION
Use care when removing or installing wiring harness. Excessive
snagging or pulling may damage wires.
REMOVAL
NOTE
Prior to removal, tag lead wires and terminals for installation.
1.
Slide handle (3) on safety switch box (2) to OFF position and open cover (5).
NOTE
Perform step 2 for M109A3 vehicles.
2.
Loosen two screws (1) and remove two wires (4) from safety switch box (2).
NOTE
Perform step 3 for M185A3 vehicles.
3.
Loosen two screws (7) and remove two wires (6) and two wires (4) from safety switch box (2).
4.
Using electrical tape, attach safety wire (8) to two wires (4).
5.
Remove four screws (11), receptacle (10), wires (4), and gasket (9) from van body (12). Discard
gasket (9).
6.
Remove safety wire (8) from two wires (4).
INSTALLATION
1.
Using electrical tape, attach safety wire (8) to two wires (4).
NOTE
Assistant will help with step 2.
2.
Pull safety wire (8) and two wires (4) through van body (12).
3.
Install new gasket (9) and receptacle (10) on van body (12) with four screws (11).
4.
Remove safety wire (8) from two wires (4).
NOTE
Perform step 5 for M185A3 vehicles.
5.
Install two wires (4) and two wires (6) on safety switch box (2) by tightening two screws (7).
NOTE
Perform step 6 for M109A3 vehicles.
6.
Install two wires (4) on safety switch box (2) by tightening two screws (1).
7.
Close cover (5) on safety switch box (2) and slide handle (3) to ON position.
8.
Connect battery ground cable (WP 0126 00).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0309 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version