 |
|||
|
|
|||
|
Page Title:
SEPARATOR ELEMENT TEST VALVE, GAUGE, AND LINES MAINTENANCE (M49A2C) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0285 00
SEPARATOR ELEMENT TEST VALVE, GAUGE, AND LINES MAINTENANCE (M49A2C) (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flames. Injury or death to personnel may result.
REMOVAL
1.
Remove two tubes (14), line (15), five adapters (3), and elbow (11) from filter separator (1) and
selector valve (9).
2.
Remove two locknuts (10), screws (6), instruction plate (7), and selector valve (9) from bracket (8).
Discard locknuts (10).
3.
Remove two locknuts (16), screws (5), and bracket (8) from shelf (2). Discard locknuts (16).
4.
Remove gauge (12) from elbow (13) and elbow (13) from selector valve (9).
INSPECTION
Clean and inspect fittings (4) for cracks or stripped threads. Replace fittings (4) if threads are cracked
or stripped.
INSTALLATION
NOTE
Male pipe threads must be wrapped with antiseize tape before
installation.
1.
Install elbow (13) on selector valve (9).
2.
Install gauge (12) on elbow (13).
3.
Install bracket (8) on shelf (2) with two screws (5) and new locknuts (16).
4.
Install selector valve (9) and instruction plate (7) on bracket (8) with two screws (6) and new
locknuts (10).
5.
Install elbow (11), five adapters (3), line (15), and two tubes (14) on filter separator (1) and selector
valve (9).
6.
Fill filter separator (TM 9-2320-361-10).
7.
Connect battery ground cable (WP 0126 00).
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0285 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version