 |
|||
|
|
|||
|
Page Title:
DELIVERY PUMP INLET TUBE REPLACEMENT (M49A2C) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0278 00
DELIVERY PUMP INLET TUBE REPLACEMENT (M49A2C) (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures near open
flames. Injury or death to personnel may result.
Accidental or intentional introduction of liquid contaminants into the
environment is a violation of state, federal, and military regulations. Refer to
Army POL (WP 0001 00) for information concerning storage, use, and disposal
of these liquids. Failure to do so may result in damage to environment and
health of personnel.
NOTE
Use a drain pan to capture any draining fuel. Dispose of fluids in accordance
with local policy and ordinances. Ensure all spills are cleaned up.
REMOVAL
1.
Loosen two clamps (5) on hose (6).
2.
Remove four locknuts (11), screws (7), elbow (8), and gasket (9) from discharge manifold (10).
Discard locknuts (11) and gasket (9).
3.
Remove two clamps (5) and hose (6) from inlet tube (2) and elbow (8).
4.
Remove four screws (4), lockwashers (3), inlet tube (2), and gasket (1) from delivery pump (12).
Discard lockwashers (3) and gasket (1).
INSTALLATION
1.
Install new gasket (1) and inlet tube (2) on delivery pump (12) with four screws (4) and new
lockwashers (3).
2.
Install hose (6) and two clamps (5) on inlet tube (2) and elbow (8). Do not tighten clamps (5).
3.
Install new gasket (9) and elbow (8) on discharge manifold (10) with four screws (7) and new
locknuts (11). Tighten clamps (5).
4.
Connect battery ground cable (WP 0126 00).
5.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
3
1
4
7
2
5
6
5
8
12
10
9
11
END OF WORK PACKAGE
0278 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version