 |
|||
|
|
|||
|
Page Title:
CARGO BODIES MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0262 00
CARGO BODIES MAINTENANCE (Contd)
REMOVAL (Contd)
WARNING
All personnel must stand clear during lifting operations.
A swinging or shifting load may cause injury to personnel.
NOTE
Assistant will help guide cargo body during lifting operations.
8.
Remove cargo body (1) and place on wooden supports.
NOTE
Perform steps 9 and 10 if replacing cargo body.
9.
Remove cargo body tailgate (3) (WP 0255 00).
10.
Remove cargo body dropside (2) (M35A2C) (WP 0259 00).
11.
Remove one frame sill (4) from each frame rail (5) for inspection.
CLEANING AND INSPECTION
1.
For general cleaning instructions of cargo body (1), refer to WP 0021 00.
2.
Inspect all screws, washers, and springs for defects. Replace if defective.
3.
Inspect frame sills (4) for end splits or rotting. Replace if end split(s) exceeds width of frame sill or
frame sill is rotting.
4.
Inspect cargo body (1) for structural damage or rust. Replace if damage or rust is severe and
exceeds available repair procedures.
INSTALLATION
WARNING
All personnel must stand clear during lifting operations.
A swinging or shifting load may cause injury to personnel.
NOTE
Use breaker bar to align body and frame brackets.
Assistant will help guide cargo body during lifting operations.
1.
Place one frame sill (4) on each frame rail (5).
NOTE
Perform steps 2 and 3 if installing new cargo body.
2.
Install cargo body dropside (2) (M35A2C) (WP 0259 00).
3.
Install cargo body tailgate (3) (WP 0255 00).
4.
Lift cargo body (1) off supports and lower onto frame rails (5).
0262 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version