 |
|||
|
|
|||
|
Page Title:
LEFT AND RIGHT CONLINKS MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0241 00
LEFT AND RIGHT CONLINKS MAINTENANCE (Contd)
REMOVAL
1.
Remove two nuts (8), lockwashers (7), left conlink (4), and right conlink (2) from idler shaft
links (6). Discard lockwashers (7).
2.
Remove left conlink (4) and right conlink (2) from wiper motor drive link (3).
INSTALLATION
CAUTION
The right conlink is longer than the left conlink. Ensure
conlinks are installed in the correct locations. Failure to do so
will result in damage to equipment.
1.
Install left conlink (4) and right conlink (2) on wiper motor drive link (3).
2.
Install left conlink (4) and right conlink (2) to idler shaft links (6) with two new lockwashers (7)
and nuts (8).
ADJUSTMENT
1.
Remove two nuts (8), lockwashers (7), left conlink (4), and right conlink (2) from idler shaft
links (6). Discard lockwashers (7).
2.
Position wiper arms (9) approximately 2 in. (5 cm) from edge of windshield frame (10).
3.
Loosen two jamnuts (1) on locking ball joints (5) and on right conlink (2) and left conlink (4).
4.
Shorten or lengthen locking ball joints (5) until they align with holes in idler shaft links (6).
NOTE
Check operation of windshield wipers to ensure correct wiper
travel and linkage is free of binding.
5.
Tighten jamnuts (1) on right conlink (2) and left conlink (4).
6.
Install left conlink (4) and right conlink (2) on two idler shaft links (6) with two new
lockwashers (7) and nuts (8).
7.
Install conlink covers (WP 0240 00).
8.
Connect battery ground cable (WP 0126 00).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0241 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version