 |
|||
|
|
|||
|
Page Title:
WINDSHIELD ASSEMBLY MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0228 00
WINDSHIELD ASSEMBLY MAINTENANCE (Contd)
ASSEMBLY
1.
Install two upper hinges (29) on lower hinges (25) with hinge bolts (24) and nuts (27).
2.
Install two studs (23) and knobs (22) in upper hinges (29). Do not tighten knobs (22) if vehicle is
equipped with hardtop kit.
INSTALLATION
1.
Install retainer (16) on windshield frame (5) with two screws (15) and seal (14).
2.
Install retainer (8) on windshield frame (5) with four screws (9) and seal 10).
3.
Install retainer nut (6) and snap fastener stud (7) on windshield frame (5).
4.
Apply adhesive to mounting side of new weatherstrip (1) and windshield frame (5) mounting
surface. Install weatherstrip (1) on windshield frame (5) mounting surface.
5.
Install two new weatherstrips (20) and plates (19) on two brackets (18) with four screws (21).
6.
Install two brackets (18) on windshield frame (5) with four screws (17).
NOTE
Two lower hinges are attached to cab by six screw-assembled
lockwashers. Exhaust support is attached to lower right hinge
and cab by a longer screw and lockwasher.
Assistant will help with step 4.
7.
Install windshield frame (5) in place on cab (32), and install hinges (29) and (31) on windshield
frame (5) with six new screw-assembled lockwashers (28).
8.
Install lower right hinge (30) on exhaust support (36) and cab (32) with new lockwasher (33) and
screw (34).
9.
Install lower right hinge (30) on cab (32) with six new screw-assembled lockwashers (35).
NOTE
Perform steps 7 through 9 on vehicles equipped with hardtop kit.
10.
Tighten knobs (22) against hinges (29) and (31).
11.
Install cab hardtop (13) on windshield frame (5) with two screws (2), spacers (3), and new
locknuts (4).
12.
Install cab hardtop (13) on windshield frame (5) with two screws (12) and new lockwashers (11).
13.
Install conlinks (WP 0241 00).
14.
Install wiper switch, motor, and conlink covers (WP 0240 00).
15.
Install cab soft top (TM 9-2320-361-10).
16.
Connect battery ground cable (WP 0126 00).
17.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0228 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version