 |
|||
|
|
|||
|
Page Title:
CAB DOOR GLASS ASSEMBLY AND WEATHERSEAL REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0210 00
CAB DOOR GLASS ASSEMBLY AND WEATHERSEAL REPLACEMENT (Contd)
REMOVAL
1.
Lower cab door glass (9) so regulator channels (2) are accessible through cab door (4) inspection
hole (7).
NOTE
Prior to removal, mark position of regulator stop brackets for
installation.
2.
Remove four screws (8), lockwashers (6), and two window regulator stop brackets (5) from
regulator channels (2). Discard lockwashers (6).
3.
Remove two fasteners (1) from window regulator arm studs (3). Discard two fasteners (1).
4.
Pull two regulator arm studs (3) out of two regulator channels (2) and slide cab door glass (9) out
of cab door (4).
5.
Remove weatherseal (11) from cab door (4).
6.
Remove five clips (10) from weatherseal (11).
INSTALLATION
1.
Install five clips (10) to weatherseal (11) and align clips (10) with panel slots (12).
2.
Install weatherseal (11) and clips (10) on cab door (4) so clips (10) snap into corresponding panel
slots (12).
3.
Slide cab door glass (9) into cab door (4) and install two window regulator arm studs (3) through
two regulator channels (2).
4.
Install two new fasteners (1) on window regulator arm studs (3).
5.
Install two window regulator stop brackets (5) on regulator channels (2) with four new
lockwashers (6) and screws (8). Do not tighten screws (8).
CAB DOOR GLASS ADJUSTMENT
1.
Raise cab door glass (9) to full up position.
NOTE
Ensure cab door glass meets glass seal at top with door in
closed position.
2.
Lower cab door glass (9) and tighten screws (8).
3.
Install door inspection hole cover (WP 0207 00).
4.
Connect battery ground cable (WP 0126 00).
5.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0210 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version