 |
|||
|
|
|||
|
Page Title:
REAR HUB AND DRUM MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0188 00
REAR HUB AND DRUM MAINTENANCE (Contd)
ASSEMBLY
1.
Install new inner bearing seal (5) and inner bearing (4) on spindle (6).
2.
Install six new wheel studs (10) on hub (11).
3.
Install adapter (1) on hub (11) with eight new lockwashers (9) and screws (8). Tighten screws (8)
81104 lb-ft (110141 Nm) and install new safety wire (7).
4.
Install hub (11) in drum (16).
5.
Install deflector (2) on adapter (1) with ten new screws (3).
6.
Install inspection cover (15), ten new lockwashers (14), and nuts (13). Tighten nuts (13) 3139 lb-ft
(4253 Nm).
INSTALLATION
CAUTION
Do not slide hub and drum assembly over threaded end of
spindle, or damage to equipment may result.
1.
Install hub (11) and drum (16) on spindle (6).
CAUTION
Do not slide seal over threaded end of spindle, or damage to seal
may result.
2.
Install outer bearing (17) and new cork gasket (12) in keyway of spindle (6), and install new outer
bearing seal (18) on spindle (6).
3.
Install inner adjusting nut (19) on spindle (6), and adjust wheel bearings (WP 0189 00).
4.
Install new key washer (20) and outer adjusting nut on spindle (6). Bend key washer (20) tabs over
on inner adjusting nut (19) and outer adjusting nut (21).
5.
Install rear wheels (TM 9-2320-361-10) but do not lower.
6.
Install rear axle shaft (WP 0147 00).
7.
Connect battery ground cable (WP 0126 00).
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
9.
Check brake adjustment (WP 0168 00).
5
3
4
2
1
6
8
7
9
15
14
10
11
13
12
17
16
18
19
20
21
END OF WORK PACKAGE
0188 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version