 |
|||
|
|
|||
|
Page Title:
WHEEL, TIRE, AND TUBE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0186 00
WHEEL, TIRE, AND TUBE MAINTENANCE (Contd)
WHEEL INSTALLATION
CAUTION
When installing stud nuts, ensure to put the curved (ball seat)
surface of the nut toward the wheel to seat properly. Failure to
do this may result in damage to wheel.
NOTE
Wear of rear dual tires should be matched as closely as
possible. Valves on rear tires must be opposite each other
(180 apart).
Ventilation holes in outer wheel should be directly aligned
with ventilation holes in inner wheel.
Nuts have left-hand threads on left wheel assembly and right
and threads on right wheel assembly. Studs and nuts are
stamped (L) left and (R) right.
Assistant will help steps 1 and 3.
If inner-rear wheel is being replaced, ensure inner stud nuts
are properly seated when installed.
If inner-rear wheel is being installed, perform step 4. If outer-
rear wheel or front wheel is being installed, go to step 5.
1.
Lift inner wheel (4) and install on wheel studs (3).
2.
Install and hand tighten six wheel capnuts (2) on wheel studs (3).
3.
Tighten six wheel capnuts (2) in tightening sequence shown 400425 lb-ft (542576 Nm).
4.
Lift wheel (1) and install on wheel capnuts (2) with six stud nuts (5). On front wheel, ensure brake
inspection plate (6) is visible through ventilation hole.
5.
Install and hand-tighten six new wheel cap nuts (5).
6.
Tighten six stud nuts (5) in sequence shown on front wheel 325355 lb-ft (441481 Nm) and six
stud nuts (5) on wheel (1) 325355 lb-ft (441481 Nm).
7.
Raise vehicle with hydraulic jack, remove jack stand, and lower vehicle to ground.
8.
Connect battery ground cable (WP 0126 00).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
5
6
3
1
2
5
3
1
5
6
JACK
STAND
4
2
TIGHTENING
4
SEQUENCE
END OF WORK PACKAGE
0186 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version