 |
|||
|
|
|||
|
Page Title:
AIRBRAKE HAND CONTROL VALVE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0178 00
AIRBRAKE HAND CONTROL VALVE REPLACEMENT (Contd)
REMOVAL
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
NOTE
Prior to removal, tag all air lines for installation.
1.
Remove valve outlet air line (8) from adapter (9).
2.
Remove two air supply lines (7) from two adapters (6).
3.
Remove two screws (2), lockwashers (3), clamp (4), and hand control valve (1) from steering
column (5). Discard lockwashers (3).
4.
Remove two adapters (6) and adapter (9) from hand control valve (1) and inspect for stripped
threads, cracks, or breaks. If cracked, broken, or threads are stripped, replace adapters (6) and (9)
and hand control valve (1).
INSTALLATION
NOTE
All male pipe threads must be wrapped with antiseize tape
before installation.
1.
Install two adapters (6) and adapter (9) on hand control valve (1).
2.
Install hand control valve (1) on steering column (5) with clamp (4), two new lockwashers (3), and
screws (2).
3.
Install two air supply lines (7) on two adapters (6).
4.
Install outlet air line (8) on adapter (9).
5.
Connect battery ground cable (WP 0126 00).
6.
Start engine (TM 9-2320-361-10), build up air pressure in air reservoirs and check operation of
airbrake hand control valve.
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0178 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version