 |
|||
|
|
|||
|
Page Title:
BRAKE PEDAL ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0174 00
BRAKE PEDAL ADJUSTMENT (Contd)
1.
Mark brake pedal rod (2) with chalk, marking it even with cab floor (3).
2.
Push brake pedal (1) down until free play is gone.
3.
Mark brake pedal rod (2) with chalk, marking it even with cab floor (3), and then release brake
pedal (1).
4.
Measure distance between two marks (4). If distance is 0.250.5 in. (6.3512.7 mm), adjustment is
correct. If out of adjustment, proceed with steps 5 through 7.
5.
Unhook spring (11) from clevis pin (8).
6.
Remove cotter pin (10), clevis pin (8), and yoke (7) from brake pedal lever (9). Discard cotter
pin (10).
7.
Loosen jamnut (5) and adjust pushrod (6) until proper adjustment is obtained.
8.
Install yoke (7) on brake pedal lever (9) with clevis pin (8).
9.
Hook spring (11) to clevis pin (8).
10.
Repeat steps 1 through 9 until free play is correct as indicated in step 4.
11.
Install new cotter pin (10) through clevis pin (8).
12.
Tighten jamnut (5) against pushrod (6).
13.
Connect battery ground cable (WP 0126 00).
14.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
4
1
2
3
0174 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version