 |
|||
|
|
|||
|
Page Title:
SERVICE BRAKE ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0168 00
SERVICE BRAKE ADJUSTMENT (Contd)
NOTE
The adjustment procedure for front and rear brakes is done
the same way.
This procedure covers the front brakes. Allow brakes to cool
before adjusting.
SERVICE BRAKE ADJUSTMENT
1.
Remove nut (1), lockwasher (2), and inspection slot cover (3) from brakedrum (4). Discard
lockwasher (2).
2.
Turn brakedrum (4) to position inspection slot (5) at 8 o'clock location.
3.
Loosen jamnut (8) on anchor pin (9) one full turn.
4.
Turn anchor pin (9) clockwise or counterclockwise until gap between brakeshoe lining (13) and
inner brakedrum surface (12) measures 0.010 in. (0.25 mm). Tighten jamnut (8) on anchor pin (9)
80110 lb-ft (109149 Nm).
5.
Turn brakedrum (4) to position inspection slot (5) at 11 o'clock location.
6.
Turn cam stud (7) clockwise until gap between brakeshoe lining (13) and inner brakedrum
surface (12) measures 0.020 in. (0.50 mm).
7.
Turn brakedrum (4) to position inspection slot (5) at 5 o'clock location.
8.
Loosen jamnut (10) on anchor pin (11) one full turn.
9.
Turn anchor pin (11) clockwise or counterclockwise until gap between brakeshoe lining (13) and
inner brakedrum surface (12) measures 0.010 in. (.25 mm). Tighten jamnut (10) on anchor pin (11)
80110 lb-ft (109149 Nm).
10.
Turn brakedrum (4) to position inspection slot (5) at 1 o'clock location.
11.
Turn cam stud (6) counterclockwise until gap between brakeshoe lining (13) and inner brakedrum
surface (12) measures .020 in. (.50 mm).
12.
Install inspection slot cover (3) on brakedrum (4) with new lockwasher (2) and nut (1).
13.
Turn brakedrum (4) by hand and turn cam stud (6) counterclockwise until brakedrum (4) drags.
Loosen cam stud (6) until brakedrum (4) slightly drags.
14.
Turn brakedrum (4) by hand and turn cam stud (7) clockwise until brakedrum (4) drags. Loosen
cam stud (7) until brakedrum (4) slightly drags.
15.
Perform steps 1 through 14 to do service adjustment of other wheel on axle.
16.
Install front or rear wheels (WP 0186 00).
17.
Connect battery ground cable (WP 0126 00).
18.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0168 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version