 |
|||
|
|
|||
|
Page Title:
PARKING BRAKE CABLE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0165 00
PARKING BRAKE CABLE (Contd)
INSTALLATION
CAUTION
Be careful when installing parking brake cable to ensure there
are no sharp bends or kinks.
1.
Install parking brake cable (4) on bracket (6), with spacer (1) and clamp (2) on groove of parking
brake cable (4), with two screws (3) and nuts (5).
2.
Install wear plate (9) on parking brake cable (4), approximately 12 in. (30.5 cm) from bracket (6),
with clamps (8) and (11), four screws (7), and nuts (10). Do not tighten nuts (10).
3.
Install threaded end (12) of brake cable (4) through eye of lever (16), and install nut (13) up to
marked location on threaded end (12).
4.
Place clamp (18) on parking brake cable (4) and install clamp (18) on transfer case (17) with new
lockwasher (19) and screw (20).
5.
Install spring (14) on lever (16) and bracket (15).
6.
Install parking brake cable (4) on frame (23) with upper clamp half (22), lower clamp half (25), two
screws (21), and nuts (24).
7.
Adjust position of wear plate (9) to protect parking brake cable (4) from rubbing on edge of
toolbox. Tighten nuts (10).
8.
Install parking brake lever (WP 0166 00).
9.
Check brakeshoe clearance (WP 0164 00).
10.
Check parking brake lever adjustment (TM 9-2320-361-10).
11.
Connect battery ground cable (WP 0126 00).
12.
Remove wheel chocks (TM 9-2320-361-10).
4
7
8
2
1
9
11
3
4
6
10
5
0165 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version