|
|
TM 9-2320-361-24-1
0162 00
TORQUE RODS REPLACEMENT (Contd)
INSTALLATION
1.
Adjust jack under tandem axle (10) until center of hole in axle bracket (11) is 7.00 0.125 in.
(17.78 0.317 cm) from lower edge of frame (13).
2.
Install one end of upper torque rod (21) on bracket (9) with new lockwasher (23) and nut (22).
Finger tighten nut (22).
3.
Install other end of upper torque rod (21) on axle bracket (11) with new lockwasher (12) and
nut (14). Tighten nuts (14) and (22) 175200 lb-ft (237271 Nm).
4.
Install brake line (18) on upper torque rod (21) with two new tiedown straps (20).
5.
Install spring saddle (25) on spring seat (19) with two U-bolts (8), four new lockwashers (16), and
nuts (17). Tighten nuts (17) 190220 lb-ft (258298 Nm).
6.
Install one end of torque rod (6) on bracket (3) with new lockwasher (4) and nut (5). Finger tighten
nut (5).
7.
Install other end of torque rod (6) on axle bracket (7) with new lockwasher (1) and nut (2). Tighten
nuts (5) and (2) 175200 lb-ft (237271 Nm).
8.
Install rear wheels (WP 0186 00).
9.
Connect battery ground cable (WP 0126 00).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0162 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |