 |
|||
|
|
|||
|
Page Title:
REAR SPRING WEAR PAD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0161 00
REAR SPRING WEAR PAD REPLACEMENT (Contd)
NOTE
This procedure covers the rear spring wear pad replacement on
the left side of the vehicle. The right side is replaced the same.
REMOVAL
1.
Raise spring seat (13) until spring (11) is lifted up in axle bracket (5) and support spring seat (13)
with jack stand.
2.
Remove locknut (12), screw (1), and clamp (2) from bracket (4). Discard locknut (12).
3.
Remove four nuts (9), lockwashers (10), screws (3), bracket (4), and axle bracket (5) from axle
housing (7) and mounting bracket (8). Discard lockwashers (10).
4.
Remove wear pad (6) from axle bracket (5). Discard wear pad (6).
INSTALLATION
1.
Install new wear pad (6) on axle bracket (5).
2.
Position axle bracket (5) over spring (11) and install on axle housing (7) and mounting bracket (8)
with brackets (4), four screws (3), new lockwashers (10), and nuts (9). Tighten nuts (9)
200275 lb-ft (271373 Nm).
3.
Install clamp (2) on bracket (4) with screw (1) and new locknut (12).
4.
Raise spring seat (13) and remove jack stand from spring seat (13).
5.
Install left rear wheels (WP 0186 00).
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0161 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version