 |
|||
|
|
|||
|
Page Title:
REAR SPRING MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0158 00
REAR SPRING MAINTENANCE (Contd)
ASSEMBLY
1.
Install two short leaf clips (4) on plate (12) with two new rivets (20).
2.
Install two long leaf clips (5) on plate (15) with two new rivets (20).
WARNING
When assembling plates and leaves with C-clamp, the plates
and leaves will be under tension. Use care not to disturb the
assembly until center bolt and nut are tightened. Failure to
comply may result in injury to personnel.
3.
Apply graphite grease between plates and while assembling.
4.
Place new center bolt (6) through lower spring leaf (9) and coat upper side of leaf (9) with graphite
grease.
5.
Install C-clamp over leaves (9) and (10) and plates (11) through (18). Ensure there is clearance for
head of center bolt (6) and nut (3). C-clamp must be squared and centered vertically across leaf
and plate assembly (19).
6.
Tighten C-clamp and install new nut (3) on new center bolt (6). Remove C-clamp and peen center
bolt (6) over nut (3).
7.
Install four spacers (7) in leaf clips (4) and (5) with four new screws (8) and new nuts (1). Tighten
nut (3) if clip is loose. Ensure leaves and plates (19) are parallel and not binding at sides of leaf
clips (4) and (5). Peen clip screws (8) over nuts (1).
8.
Install rear spring (WP 0157 00).
0158 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version