|
|
TM 9-2320-361-24-1
0152 00
TANDEM AXLE REPLACEMENT (Contd)
WARNING
Weight of vehicle must be supported on jack stands at all times.
Do not attempt to support weight of vehicle on hydraulic jack.
Injury or death to personnel may result if jack fails.
REMOVAL
1.
Install jack stands under frame of vehicle behind rear-rear axle (3).
2.
Position hydraulic jack under center of tandem axle bracket (5).
WARNING
Tandem axle is heavy. Support tandem axle during removal and
installation. Failure to do so may result in injury to personnel or
damage to equipment.
3.
Remove twelve locknuts (4) and screws (1) from tandem axle bracket (5) and two rear axle bogie
supports (2). Discard locknuts (4).
NOTE
Assistant will help with step 4.
4.
Lower hydraulic jack and remove tandem axle bracket (5) from vehicle.
INSTALLATION
NOTE
Assistant will help with step 1.
1.
Using hydraulic jack, lift tandem axle bracket (5) into position under vehicle.
2.
Install tandem axle bracket (5) on two rear axle bogie supports (2) with twelve screws (1) and new
locknuts (4). Tighten locknuts (4) 180220 lb-ft (244298 Nm).
3.
Remove hydraulic jack from under vehicle.
4.
Install rear spring seats (WP 0157 00).
5.
Connect lower torque rods (WP 0162 00).
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0152 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |