|
|
TM 9-2320-361-24-1
0147 00
REAR AXLE SHAFT MAINTENANCE (Contd)
REMOVAL
1.
Remove eight screws (1) and lockwashers (2) from flange (3) and hub (6). Discard lockwashers (2).
2.
Remove flange (3) and axle shaft (4) as an assembly, and gasket (5) from hub (6) and axle housing
(7). Discard gasket (5).
CLEANING AND INSPECTION
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap and
water. Wash contaminated clothing before reuse. Eye contact
may cause irritation, tearing, or blurring of vision. Use face
shield or goggles when eye contact may occur. In case of eye
contact, flush eyes with large amounts of water for at least 15
minutes or until irritation subsides. Inhalation may cause
irritation to upper respiratory passages. DO NOT have food or
drink in the vicinity. Failure to comply may result in injury to
personnel.
1.
Clean gasket (5) residue from mating surfaces.
2.
Clean axle shaft (4) with rag saturated in Skysol 100. Dry with clean rag,
3.
Inspect axle shaft (4) for cracks, breaks, and bends. Replace axle shaft (4) if cracked, broken, or
bent.
4.
Inspect axle shaft (4) splines for nicks, burrs, cracks, and breaks. Remove minor nicks and burrs
with a fine-mill file or emery cloth. Replace if splines are cracked or broken.
INSTALLATION
1.
Coat one side of new gasket (5) with GAA grease and align over holes in hub (6).
2.
Carefully insert axle shaft (4) into hub (6) and axle housing (7). Turn axle shaft (4) until splines of
axle shaft (4) seat in differential. Align holes of flange (3) to holes in gasket (5) and hub (6).
3.
Install flange (3) with eight new lockwashers (2) and screws (1). Tighten screws (1) 81104 lb-ft
(110189 Nm).
4.
Connect battery ground cable (WP 0126 00).
5.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0147 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |