 |
|||
|
|
|||
|
Page Title:
FRONT AXLE SHAFT AND UNIVERSAL JOINT MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0142 00
FRONT AXLE SHAFT AND UNIVERSAL JOINT MAINTENANCE (Contd)
REMOVAL
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and
military regulations. Refer to Army POL (WP 0001 00) for
information concerning storage, use, and disposal of these
liquids. Failure to do so may result in damage to environment
and health of personnel.
CAUTION
Plug all openings after disconnection to prevent contamination.
NOTE
Left and right side front axle shafts are replaced the same
way. This procedure covers the right side front axle shaft.
Use a drain pan to capture any draining oil. Dispose of fluids
in accordance with local policy and ordinances. Ensure all
spills are cleaned up.
1.
Remove screw (2), two washers (3), and hose connector (4) from wheel cylinder (1). Discard
washers (3).
2.
Remove spring (6) from brakeshoes (7).
3.
Remove twelve nuts (10), lockwashers (9), and deflector (5) from brake plate (8). Discard
lockwashers (9).
4.
Remove brake plate (8) from spindle (11).
5.
Slide spindle (11) and thin thrust washer (12) off outer shaft of front axle shaft (16).
6.
Carefully pull front axle shaft (16) out of axle housing (15) and steering knuckle (14).
7.
Remove thick thrust washer (13) from front axle shaft (16).
0142 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version