|
|
TM 9-2320-361-24-1
0141 00
UNIVERSAL JOINT MAINTENANCE (Contd)
NOTE
Align marks on yokes before assembling bearing caps in shaft
yoke.
2.
Cap type:
a. Install four new seals (8) on universal joint journals (9).
b. Install lubrication fitting (10) on universal joint (7).
c. Install universal joint (7) in upper yoke flange loop (5) with lubrication fitting (10) angled away
from yoke flange (6).
d. Apply GAA grease in bearing caps (3) to hold bearing (4) in place during assembly.
e. Install two bearing caps (3) on universal joint journal (9) and upper yoke flange loop (5).
f. Position two locking straps (2) on bearing caps (3) and install with four screws (1). Tighten
screws (1) 1825 lb-ft (2434 Nm). Bend tabs of locking straps (2) up to hold screws (1) in place.
NOTE
Align marks on yokes before assembling bearing caps in shaft
yoke.
Shaft yoke and yoke flange should move smoothly and have
no free play.
g. Position shaft yoke (11) on universal joint journals (9) and install two bearing caps (3) with
new locking straps (2) and four screws (1). Tighten screws (1) 1825 lb-ft (2434 Nm).
h. Bend tabs of locking straps (2) up to hold screws (1) in place.
3.
Install propeller shaft (WP 0139 00).
4.
Install intermediate propeller shaft (M36A2) (WP 0140 00).
8
1
9
10
2
3
7
1
2
6
3
4
10
5
9
6
3
11
2
7
1
CAP TYPE
END OF WORK PACKAGE
0141 00-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |