TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) - continued

TM 9-2320-361-24-1

0133 00

TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) (Contd)

REMOVAL (Contd)

NOTE

Perform step 2 on vehicles with transfer case lockout arms.

Remove two cotter pins (18), washers (17), and rod (24) from lock (16) and lever (19). Discard cotter

pins (18).

NOTE

Some vehicles are equipped with a screw; others use a shoulder

screw. This procedure covers a shoulder screw.

Remove two locknuts (14), shoulder screw (11), screw (35), clevis (12), and rod (26) from transfer

case shaft (13) and transfer case shift handle (27). Discard locknuts (14).

Loosen jamnut (25) and remove clevis (12) and jamnut (25) from rod (26).

NOTE

Perform steps 5 and 6 on vehicles equipped with transfer case

lockout arms.

Remove two locknuts (28), stud (32), lock (16), connector rod (31), and transfer case shift

handle (27) from transfer case shifter bracket (29). Discard locknuts (28).

Loosen jamnut (34) and remove lock (16) and jamnut (34) from connector rod (31).

Remove two locknuts (5) and ball pivot ends (7) from PTO shift lever (6) and shift arm (15).

Discard locknuts (5).

Loosen two jamnuts (8) and remove two ball pivot ends (7) and jamnuts (8) from rod (9).

NOTE

Perform steps 9 through 12 on vehicles equipped with transfer

case lockout arms.

Remove two cotter pins (10), clevis pins (4) and (38), clevis (3), and rod (1) from PTO shift lever (6)

and lever (36). Discard cotter pins (10). Clevis pin (38) remains attached to speed control cable (37)

on vehicles with speed control cables.

10.

Loosen jamnut (2) and remove clevis (3) and jamnut (2) from rod (1).

11.

Remove three locknuts (30), screws (22), and bracket (23) from frame (33) and transfer case shifter

bracket (29). Discard locknuts (30).

12.

Remove straight pin (20), levers (19) and (36), and two bushings (21) from bracket (23). Discard

bushings (21).

0133 00-2