|
|
TM 9-2320-361-24-1
0113 00
HORN BUTTON REPLACEMENT (Contd)
REMOVAL
1.
Remove three screws (4) and lift horn button adapter (3) from center of steering wheel (1).
Disconnect horn button connector (7) from wire connector (10).
2.
Remove spring (9) and seal (2).
3.
Remove retaining ring (6), horn button (5), and O-ring (8) from adapter (3). Discard O-ring (8).
NOTE
Perform steps 4 through 8 only if horn wire is damaged.
4.
Disconnect plug (16) from connector (15) and slide shell (14) back on horn wire (12).
5.
Remove slotted washer (18) from behind connector (15) and slide shell (14) off end of wire (12).
6.
Remove rubber bushing (13) from steering gearbox (19) and slide bushing (13) off end of wire (12).
NOTE
If horn wire is damaged, perform steps 7 and 8.
Safety wire must be long enough to reach from other end of
steering column plus two additional feet.
7.
Attach safety wire (17) to horn wire (12).
NOTE
Safety wire must be left inside steering column. It will be used
to pull new horn wire through steering column.
8.
Pull horn wire (12) through steering column (11). Leave safety wire (17) in steering column (11).
INSTALLATION
NOTE
If horn wire has not been removed, proceed to step 6.
1.
Pull horn wire (12) through steering column (11). Make sure horn wire (12) is taut between
steering column (11) and connector (15). Discard safety wire (17).
2.
Install rubber bushing (13) on horn wire (12) and insert into hole in steering gearbox (19).
3.
Move shell (14) upward on wire (12) and install slotted washer (18) behind connector (15). Slide
shell (14) over slotted washer (18).
4.
Connect plug (16) to connector (15).
5.
Install spring (9) and seal (2) in steering column (11).
6.
Install retaining ring (6), horn button (5), and new O-ring (8) in adapter (3).
7.
Connect wire connector (10) to horn button connector (7).
8.
Install horn adapter (3) in steering column (11) and steering wheel (1) with three screws (4).
9.
Connect battery ground cable (WP 0126 00).
10.
Check horn for proper operation (TM 9-2320-361-10).
11.
Connect battery ground cable (WP 0126 00).
12.
Lower and secure hood (TM 9-2320-361-10).
12.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0113 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |