|
|
TM 9-2320-361-24-1
0111 00
HEADLIGHT BEAM SELECTION SWITCH REPLACEMENT (Contd)
REMOVAL
1.
Remove two screws (1) and lockwashers (9) from headlight beam selection switch (8). Discard
lockwashers (9).
2.
Push headlight beam selection switch plunger (4) through floorboard (2) and slide headlight beam
selection switch (8) away from protective cover (3).
NOTE
Prior to removal, tag lead wires for installation.
3.
Disconnect wires (5), (6), and (7) from headlight beam selection switch (8).
INSTALLATION
1.
Connect three wires (5), (6), and (7) to headlight beam selection switch (8).
NOTE
Assistant will help with steps 2 and 3.
2.
Position headlight beam selection switch plunger (4) through floorboard (2). Install two new
lockwashers (9) and screws (1) to headlight beam selection switch (8). Do not tighten screws (1).
3.
Position protective cover (3) over headlight beam selection switch (8). Slide slotted side of cover (3)
on headlight beam selection switch (8) and floorboard (2). Tighten screws (1).
4.
Connect battery ground cable (WP 0126 00).
5.
Check operation of headlight beam selecting switch (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
2
1
9
3
4
5
8
7
6
END OF WORK PACKAGE
0111 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |