 |
|||
|
|
|||
|
Page Title:
REAR WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0092 00
REAR WIRING HARNESS REPLACEMENT (Contd)
REMOVAL (Contd)
2.
Remove locknut (12), lockwasher (13), ground wire (14), and screw (2) from support (1). Discard
locknut (12) and lockwasher (13).
3.
Disconnect plug (11) from fuel pump (10).
4.
Disconnect wire (8) from fuel level sending unit (9).
5.
Remove two locknuts (7), screws (4), and clamps (3) from rear wiring harness (5) and
crossmember (6). Discard locknuts (7).
NOTE
Steps 6 and 7 cover left side composite light.
6.
Disconnect wires (22), (23), (24), and (25) from composite light wires (21), (20), (19), and (18).
7.
Remove locknut (26), screw (16), and clamp (15) from bracket (17) and rear wiring harness (5).
Discard locknut (26).
8.
Repeat steps 6 and 7 for right side composite light.
NOTE
All trailer receptacles are removed basically the same.
9.
Remove four locknuts (44), lockwashers (43), ground wire (28), four screws (40), cap (39), and
receptacle (27) from bracket (42). Discard locknuts (44) and lockwashers (43).
10.
Remove two locknuts (36), screws (41), and clamps (37) from tail frame (38) and rear wiring
harness (5). Discard locknuts (36).
11.
Remove four locknuts (29), screws (32), nut (35), and five clamps (30) and (34) from frame (31),
stud (33), and rear wiring harness (5). Discard locknuts (29).
2
1
14
5
4
13
3
12
6
7
8
11
9
10
0092 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version