FRONT WIRING HARNESS REPLACEMENT - continued

TM 9-2320-361-24-1

0091 00

FRONT WIRING HARNESS REPLACEMENT (Contd)

INSTALLATION (Contd)

21.

Position bracket (4) on two screws (5) so that front wiring harness (8) is between bracket (4) and

steering column (9). Tighten two screws (5).

22.

Connect plug (2) to signal switch (1).

23.

Install clamp (6) on steering column (9) and front wiring harness (8) with screw (7) and nut (3).

24.

Install wire (28) on flasher unit (25) with new lockwasher (26), screw (27), new lockwasher (29),

and nut (30).

25.

Connect plug (24) to flasher unit (25).

26.

Connect wires (18), (19), and (20) to beam selector switch (22).

27.

Connect wires (16) and (17) to circuit breaker (15).

NOTE

Assistant will help with steps 28 through 30.

28.

Install two clamp halves (13) on firewall (21) with washer (32), clamp (12), two screws (11), and

new locknuts (14).

29.

Remove slack from front wiring harness (8).

30.

Install four clamps (31) on front wiring harness (8) and firewall (21) with four screws (23) and new

locknuts (10).

0091 00-12