 |
|||
|
|
|||
|
Page Title:
FRONT WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0091 00
FRONT WIRING HARNESS REPLACEMENT (Contd)
REMOVAL (Contd)
51.
Disconnect wires (10) and (11) from stoplight switch (12).
52.
Remove two locknuts (14), screws (13), front wiring harness (1), and horn rear wiring harness (15),
from brace (16). Discard locknuts (14).
53.
Remove two locknuts (2), screws (8), and clamps (3) from brace (4), front wiring harness (1), and
frame (9). Discard locknuts (2).
54.
Remove nut (5) and clamp (7) from front wiring harness (1) and U-bolt (6).
CAUTION
Use care when removing front wiring harness. Snagging and
pulling may cause damage to harness.
55.
Remove front wiring harness (1) from left side frame (17), right side frame (18), over steering
column (19), and through firewall (21).
INSTALLATION
CAUTION
Use care when routing front wiring harness. Snagging and
pulling may cause damage to front wiring harness.
NOTE
If new wiring harness is to be installed, remove tags from old
harness and install on new harness.
For additional wiring harness installation information, refer
to Electrical System Wiring Diagram (WP 0473 00).
1.
Install front wiring harness (1) through firewall (21), over steering column (19), left side
frame (17), and right side frame (18), and under cab (20).
5
4
3
2
6
3
7
9
1
16
10
15
8
11
12
13
14
0091 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version