 |
|||
|
|
|||
|
Page Title:
EXHAUST SYSTEM REPLACEMENT (M50A3) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0074 00
EXHAUST SYSTEM REPLACEMENT (M50A3) (Contd)
INSTALLATION (Contd)
6.
Install new gasket (12) and elbow (11) on turbocharger (14) with clamp (13). Do not tighten
clamp (13).
7.
Install new gasket (10) and flex tube (17) on elbow (11) with coupling (16), screw (9), and new
locknut (15).
8.
Install new gasket (25) and Y-pipe (31) on flex tube (17) with coupling (23), screw (22), and new
locknut (24).
9.
Install clamp (28) and Y-pipe (31) on bracket (27) with washer (29), screw (30), washer (26), and
new locknut (21).
10.
Install two cover plates (20) on fender (34) with two washers (35), screws (36), washers (33), and
new locknuts (32).
11.
Tighten clamp (13) on elbow (11).
12.
Install U-bolt (37) and clamp (19) on Y-pipe (31) and bracket (7) with two new lockwashers (18)
and nuts (8).
13.
Install exhaust shield (38) on Y-pipe (31) with two clamps (5), four screws (39), and new
locknuts (6).
14.
Install new gasket (42) and exhaust pipe (3) on Y-pipe (31) with coupling (41), screw (40), and new
locknut (4).
15.
Install exhaust stack shutoff (1) on exhaust pipe (3) with screw (2) and new locknut (43). Do not
tighten locknut (43).
16.
Position exhaust stack shutoff (1) so exhaust gases are directed approxomately 45 out from rear
of vehicle.
17.
Tighten locknut (43) on exhaust stack shutoff (1).
18.
Install air cleaner element (WP 0052 00).
19.
Connect battery ground cable (WP 0126 00).
20.
Lower and secure hood (TM 9-2320-361-10).
21.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
22.
Start engine (TM 9-2320-361-10) and check for exhaust leaks.
0074 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version