|
|
TM 9-2320-361-24-1
0073 00
EXHAUST SYSTEM REPLACEMENT (ALL EXCEPT M50A3) (Contd)
INSTALLATION
1.
Install exhaust pipe (29) on fender (32).
2.
Install exhaust pipe (29) on bracket (16) with U-bolt (35), clamp (17), two new lockwashers (6), and
nuts (5).
3.
Install exhaust pipe (29) on bracket (25) with clamp (26), washer (27), screw (28), washer (19), and
new locknut (20).
4.
Install cover plates (18) on fender (32) with two washers (33), screws (34), washers (31), and two
new locknuts (30).
5.
Install exhaust shield (36) on exhaust pipe (29) with two clamps (3), four screws (37), and new
locknuts (4).
6.
Install new gasket (40) and stack pipe (1) on exhaust pipe (29) with coupling (39), screw (38), and
new locknut (2). Do not tighten locknut (2).
7.
Position outlet of stack pipe (1) outward and approximately 45 to rear of vehicle. Tighten
coupling (39).
8.
Install new gasket (24) and flex tube (15) on exhaust pipe (29) with coupling (23), screw (21), and
new locknut (22). Do not tighten locknut (22).
9.
Install new gasket (10) and elbow (9) on turbocharger (12) with clamp (11). Do not tighten
clamp (11).
10.
Install new gasket (8) and flex tube (15) on elbow (9) with coupling (14), screw (7), and new
locknut (13). Tighten coupling (14).
11.
Tighten clamp (11) and coupling (23).
12.
Install air cleaner element (WP 0052 00).
13.
Connect battery ground cable (WP 0126 00).
14.
Start engine (TM 9-2320-361-10).
15.
Lower and secure hood (TM 9-2320-361-10).
16.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0073 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |