|
|
TM 9-2320-361-24-1
0070 00
ACCELERATOR PEDAL, BRACKETS, AND ROD MAINTENANCE (Contd)
REMOVAL
1.
Remove throttle return spring (10) from swivel (9) and throttle return clip (1).
2.
Remove screw (3), washers (2), and throttle return clip (1) from steering gear housing (12).
3.
Remove cotter pin (4) and pin (11) from swivel (9) and disconnect swivel (9) from pump lever (13).
Discard cotter pin (4).
4.
Loosen screw (5) and remove connector (6), screw (5), and control wire (7) from flange on
accelerator rod (8).
5.
Remove locknut (19), ball joint (21), and accelerator rod (22) from lever (20). Discard locknut (19).
6.
Remove cotter pin (18), washer (17), and connecting link (16) from lever (20). Discard cotter
pin (18).
7.
Remove two cotter pins (14), pin (15), and lever (20) from bracket (24). Discard cotter pins (14).
NOTE
Assistant will help with step 8.
8.
Remove two locknuts (25), screws (26), and bracket (24) from cab floor (23). Discard locknuts (25).
0070 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |