 |
|||
|
|
|||
|
Page Title:
FUEL INJECTOR NOZZLE AND HOLDER MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0067 00
FUEL INJECTOR NOZZLE AND HOLDER REPLACEMENT (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flame. Injury to personnel may result.
CAUTION
Cap or plug all openings immediately after disconnecting lines
and hoses to prevent contamination. Remove caps or plugs prior
to installation. Failure to do so may result in damage to
equipment.
NOTE
All fuel injector nozzle and holder assemblies are removed and
installed basically the same. This procedure covers no. 4
cylinder injector nozzle.
REMOVAL
1.
Loosen tube nut (12) on fuel injector tube (6) and disconnect from fuel injector nozzle (4).
2.
Remove locknut (11), screw (9), washer (8), two retainers (7), and cushions (10) from injector
tubes (5) and (6). Discard locknut (11).
3.
Remove two screws (1), lockwashers (2), fuel injector holder (3), and fuel injector nozzle (4) from
engine (13). Discard lockwashers (2).
4.
Remove dust seal (14) from fuel injector nozzle body (15). Retain dust seal (14) if serviceable. For
fuel injector nozzle cleaning, inspection, and repair procedures, refer to TM 9-2815-210-34-2-2.
INSTALLATION
1.
Apply a coat of silicone compound to fuel injector nozzle body (15).
2.
Install dust seal (14) onto fuel injector nozzle body (15).
3.
Install fuel injector nozzle (4) and holder (3) into engine (13) with two new lockwashers (2) and
screws (1).
4.
Evenly tighten two screws (1) 1315 lb-ft (1720 Nm).
5.
Connect fuel injector tube (6) to fuel injector nozzle (4) with tube nut (12).
6.
Install two cushions (10) and retainers (7) on fuel injector tubes (5) and (6) with washer (8),
screw (9), and new locknut (11).
7.
Install fuel return tees and tubes (WP 0068 00).
8.
Bleed fuel system (WP 0064 00).
9.
Start engine (TM 9-2320-361-10) and check for fuel leaks.
10.
Connect battery ground cable (WP 0126 00).
11.
Lower and secure hood (TM 9-2320-361-10).
12.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0067 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version