|
|
TM 9-2320-361-24-1
0061 00
FUEL PUMP (IN-TANK) MAINTENANCE (Contd)
INSTALLATION
NOTE
If new fuel pump is installed, measurement "A" must be 15.1 in.
(38.4 cm).
If necessary to adjust fuel pump length, perform steps 1
through 5.
1.
Remove pump (8) from clamp (12).
2.
Remove two nuts (11), washers (10), and screws (7) from clamp (12) and fuel pump bracket (6).
3.
Install pump (8) on clamp (12) and position pump (8) up or down in fuel pump bracket (6) to give
correct measurement.
4.
Remove pump (8) from clamp (12) and install two screws (7), washers (10), and nuts (11) on fuel
pump bracket (6) and clamp (12).
5.
Install pump (8) in clamp (12).
6.
Install new gasket (9) and fuel pump assembly (5) on fuel tank (13) with ten screws (1).
7.
Install fuel tank (WP 0060 00).
NOTE
Male pipe threads must be wrapped with antiseize tape before
installation.
8.
Connect fuel supply tube (4) to fuel pump assembly (5).
9.
Install elbow (2) on fuel pump assembly (5) and connect vent tube (3) to elbow (2).
WARNING
Some vehicles have two separate wires and connectors.
Connecting wires on wrong terminals may cause fuel to ignite,
resulting in injury to personnel and/or damage to equipment.
10.
Connect connector (15) to terminal cover (14).
11.
Connect battery ground cable (WP 0126 00).
12.
Start engine (TM 9-2320-361-10), check operation of fuel pump, and check for fuel leaks.
13.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
2
3
1
4
5
15
14
13
6
12
A
7
8
11
9
10
END OF WORK PACKAGE
0061 00-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |