 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0046 00
ENGINE REPLACEMENT (Contd)
INSTALLATION (Contd)
5.
Install two rear engine supports (2) on engine (1) with eight new locknuts (3). Tighten locknuts (3)
4555 lb-ft (6175 Nm).
6.
Install two front engine supports (9) on engine (1) with four washers (4), two screws (5), and
screws (6). Tighten screws (5) and (6) 200250 lb-ft (271339 Nm).
7.
Install support plate (10) on two front engine supports (9) with six washers (8) and screws (7).
Tighten screws (7) 2427 lb-ft (3337 Nm).
8.
Install chain on rear lifting bracket (16) with washers (14) and (13), screw (16), and nut (15).
9.
Connect lifting device to sling.
10.
Connect sling to front lifting bracket (11) and chain.
WARNING
Lifting device must have a weight capacity greater than the
weight of the engine and transmission to prevent damage to
equipment and injury to personnel.
All personnel must stand clear during lifting operations. A
swinging or shifting load may cause injury to personnel.
Use prybar to free engine during lifting operations. Failure to
do so may cause injury to personnel.
Do not detach chain from engine until all engine weight is
equally distributed and engine is stable. An improperly
supported engine may cause injury to personnel.
11.
Raise engine (1) from supports.
NOTE
Two assistants will help with step 12.
Engine angle must be adjusted constantly during engine
installation.
12.
Lower engine (1) into engine compartment. Do not lower completely.
1
2
3
4
5
4
6
9
7
8
10
0046 00-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version