ENGINE REPLACEMENT - continued - TM-9-2320-361-24-10510

TM 9-2320-361-24-1

0046 00

ENGINE REPLACEMENT (Contd)

REMOVAL (Contd)

NOTE

Do not remove spring-loaded pin from clevis. Bearing will fall

free from clevis if pin is removed.

Step 32 applies to vehicles equipped with transmission power

takeoff.

32.

Pull pin (10) to one side of clevis (11) and remove clevis (11) from Power Takeoff (PTO) arm (8).

33.

Install chain to rear lifting bracket (5) with two washers (3), screw (2), and nut (4).

34.

Connect lifting device to sling.

35.

Connect sling to front lifting bracket (1) and chain.

36.

Remove two locknuts (15), washers (14), lower mounting pads (13), screws (6), and washers (7)

from frame (12). Discard locknuts (15).

37.

Remove two locknuts (16), washers (17), lower mounting pads (18), screws (23), and washers (22)

from support plate (21) and crossmember (19). Discard locknuts (16).

WARNING

Lifting device must have a weight capacity greater than the

weight of the engine and transmission to prevent damage to

equipment and injury to personnel.

All personnel must stand clear during lifting operations. A

swinging or shifting load may cause injury to personnel.

Use prybar to free engine during lifting operations. Failure to

do so may cause injury to personnel.

Do not detach chain from engine until engine is supported on

engine stand. An improperly supported engine may cause

injury to personnel.

CAUTION

Closely observe all engine and transmission attachments during

removal to prevent damage to equipment.

NOTE

Assistant will help with step 38.

Engine angle must be adjusted constantly during engine

removal.

38.

Raise engine (24) from engine compartment.

39.

Lower engine (24) and position on supports.

40.

Remove lifting device and sling from chain and front lifting bracket (1).

41.

Remove nut (4), screw (2), two washers (3), and chain from rear lifting bracket (5).

42.

Remove two mounting pads (9) and (20) from frame (12) and crossmember (19).

0046 00-10