 |
|||
|
|
|||
|
Page Title:
ENGINE OIL FILTER HOUSING MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0039 00
ENGINE OIL FILTER HOUSING MAINTENANCE (Contd)
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use, and disposal of these liquids. Failure to
do so may result in damage to environment and health of
personnel.
NOTE
Use a drain pan to capture any draining oil. Dispose of fluids in
accordance with local policy and ordinances. Ensure all spills
are cleaned up.
REMOVAL
1.
Remove plug (17). Allow coolant to drain.
2.
Loosen two clamps (2).
3.
Remove seventeen screws (12) and washers (11) from engine block (4) and housing (6).
4.
Remove housing (6) and gasket (19) from hose (3) and engine block (4). Discard gasket (19).
5.
Remove two clamps (2) and hose (3) from coolant tube (1). Discard hose (3).
DISASSEMBLY
1. Remove two oil pressure plugs (14), gaskets (13), springs (15), and valves (16) from housing (6).
Discard gaskets (13).
2. Remove two adapter bushings (5) from housing (6).
3. Remove plug (18) from housing (6).
4. Remove drain valve (9) and adapter (8) from housing (6).
INSPECTION
1. Refer to WP 0021 00 for inspection instructions.
2. Inspect twelve studs (7) and stud (10) for damage. If stud(s) is damaged, replace.
3. Inspect housing (6) for cracks. If housing (6) is damaged, replace.
ASSEMBLY
1. Apply light coat of sealant to threads of adapter (8), drain valve (9), and plugs (18) and (17).
2. Install adapter (8) and drain valve (9) in housing (6).
3. Install plugs (18) and (17) in housing (6).
4. Coat outer threads of two bushings (5) with sealing compound.
5. Install two adapter bushings (5) in housing (6).
6. Install two valves (16), springs (15), new gaskets (13), and oil pressure plugs (14) in housing (6).
INSTALLATION
1. Install new hose (3) and two clamps (2) on coolant tube (1). Do not tighten clamps (2).
2. Apply light coat of sealing compound to threads of seventeen screws (12).
3. Apply light coat of sealing compound to new gasket (19).
4. Install new gasket (19) and housing (6) on engine block (4) with seventeen washers (11) and
screws (12).
5. Install hose (3) on housing (6) and tighten two hose clamps (2).
6. Install engine oil cooler (WP 0038 00).
7. Install engine oil filters (WP 0044 00).
8. Connect battery ground cable (WP 0126 00).
9. Lower and secure hood (TM 9-2320-361-10).
10. Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0039 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version