 |
|||
|
|
|||
|
Page Title:
TIMING GEARS COVER AND GASKET REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0032 00
TIMIMG GEARS COVER AND GASKET REPLACEMENT (Contd)
Water pump and housing removed (WP 0082 00).
REMOVAL
1.
Remove nut (21) and lockwasher (20) from timing cover stud (23). Discard lockwasher (20).
2.
Remove four nuts (12), lockwashers (11), screws (22), access cover (19), and gasket (18). Discard
lockwashers (11) and gasket (18).
3.
Remove seven screws (25) and lockwashers (24) from adapter plate (13) and timing
cover (4). Discard lockwashers (24).
4.
Remove nut (8), lockwasher (7), nut (10), lockwasher (9), and screws (1) and (26) from adapter
plate (13) and timing cover (4). Discard lockwashers (7) and (9).
5.
Remove nut (2) and lockwasher (3) from timing cover (4) and stud (6). Discard lockwasher (3).
6.
Remove four screws (16) and lockwashers (17) from timing cover (4) and oil pan (14). Discard
lockwashers (17).
CAUTION
Oil pan gasket may stick to timing cover. Use care when
removing timing cover from oil pan. Failure to do this may
damage oil pan gasket.
7.
Remove timing cover (4) and gasket (5) from adapter plate (13) and oil pan gasket (15). Discard
gasket (5).
8.
Remove all remaining gasket (5) material from timing cover (4) and adapter plate (13).
INSTALLATION
1.
With new gasket (5) laying flat on timing cover (4), trim bottom edges of gasket (5) even with
bottom edge of timing cover (4).
2.
Apply a thin, even coat of gasket sealing compound on both sides of timing cover gasket (5) and
exposed surface of oil pan gasket (15).
3.
Apply a thin coat of thread locking sealing compound on threads of seven screws (25).
4.
Install gasket (5) and timing cover (4) on adapter plate (13) with seven new lockwashers (24) and
screws (25).
5.
Install screws (1) and (26) through timing cover (4) and adapter plate (13) with new
lockwashers (7) and (9) and nuts (8) and (10).
6.
Install new lockwasher (3) and nut (2) on stud (6) and timing cover (4).
7.
Install timing cover (4) on oil pan (14) with four new lockwashers (17) and screws (16).
8.
Install new gasket (18) and access cover (19) on timing cover (4) with new lockwasher (20),
nut (21), four screws (22), new lockwashers (11), and nuts (12).
9.
Install water pump and housing (WP 0082 00).
10.
Install tachometer cable adapter (WP 0098 00).
11.
Install vibration damper (WP 0028 00).
12.
Connect battery ground cable (WP 0126 00).
13.
Lower and secure hood (TM 9-2320-361-10).
0032 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version