Click here to make tpub.com your Home Page

Page Title: ROCKER ARM COVERS REPLACEMENT - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-361-24-1
0030 00
ROCKER ARM COVERS REPLACEMENT (Contd)
FRONT ROCKER ARM COVER INSTALLATION
1.
Apply thin coat of sealing compound on both sides of new gasket (26).
2.
Apply thin coat of sealing compound on threads of new lockscrews (2), (13), and (10).
3.
Install new gasket (26) and rocker arm cover (27) on cylinder head (23) with washer (28) and new
locknut (29). Do not tighten locknut (29).
4.
Install four washers (1) and lockscrews (2) on rocker arm cover (27). Do not tighten lockscrews (2).
5.
Install two brackets (12) on rocker arm covers (27) and (5) with washers (11) and lockscrews (10).
Do not tighten lockscrews (10).
6.
Install two hangers (15) on rocker arm cover (27) with washers (14) and lockscrews (13).
7.
Install retainer (30) on water outlet manifold (25) with washer (31) and screw (32). Install oil
cap (33) on rocker arm cover (27).
8.
Tighten lockscrews (2), (13), and (10) and locknut (29) 30 lb-in. (3 Nm). Repeat tightening until
5060 lb-in. (67 Nm) is achieved.
9.
Tighten two screws (21) on front lifting bracket (22).
10
Install clevis (19) on bracket (17) and front lifting bracket (22) with screws (24) and (21) and
nuts (16) and (18).
11.
Install personnel heater hoses (35) on bracket (38) with clamp (37), screw (36), clamp (34), and new
locknut (39).
REAR ROCKER ARM COVER INSTALLATION
1.
Apply thin coat of sealing compound on both sides of new gasket (8).
2.
Apply thin coat of sealing compound on threads of new lockscrews (6) and (10).
3.
Install new gasket (8) and rocker arm cover (5) on cylinder head (9) with washer (4) and new
locknut (3). Do not tighten locknut (3).
4.
Install rocker arm cover (5) on cylinder head (9) with six washers (7) and lockscrews (6). Do not
tighten lockscrews (6).
5.
Install two brackets (12) on rocker arm covers (5) and (27) with washers (11) and lockscrews (10).
Do not tighten lockscrews (10).
6.
Tighten lockscrews (6) and (10) and locknut (3) 30 lb-in. (3 Nm). Repeat tightening until
5060 lb-in. (67 Nm) is achieved.
7.
Install crankcase breather tube adapter (WP 0043 00).
8.
Connect battery ground cable (WP 0126 00).
9.
Lower and secure hood (TM 9-2320-361-10).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0030 00-4

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business